How much does it cost to change automatic to manual transmission?
About 4 thousand dollars. You'll need a transmission, clutch, new brake pedal assembly, new clutch pedal assembly, clutch master cylinder and line, shifter assembly, entire new engine/transmission wiring harness entire new interior wiring harness, Then there's the labor to install the brake/clutch pedals, remove the automatic shifter and cut the floorboards for the shifter control levers, You'll also need a new PCM and send the vehicle to the dealer to have it programmed That's all gonna take a week in a shop to complete. Got the time and money? And since the car is barely worth 4 grand, you'd be better off leaving it stock or selling it and getting a vehicle that has a factory equipped manual transmission.
How much does changing transmission from manual to automatic cost?-Hyundai Tiburon?
That isn't really possible without a lot of money and a lot of work for a vehicle that isn't worth it (nothing against the car, it's just the value vs. cost of mod.) It isn't just swapping the gearboxes and shifters. You'll need the TCU (transmission control unit) for an auto, a new ECU (engine control unit) for an auto instead of a manual, and new engine bay and cabin wire harnesses to get the brains working. Not practical.
How much does it cost to change a manual transmission car to an automatic transmission in India?
Changing from manual to automatic trans may cost a lot because it needs certain replacement parts likeTransmission casingFluid CouplingAutomatic gear selector leverSensors and EGC SwitchesNew Planetery gear setupfocusing directly on costs so you got to be paying about 75k - 100k INR for an used condition transmission getting into your car and if you opt for new setup then it will cost about diamonds !!!only if you chose to replace it .
How much to change from automatic transmission to manual transmission in my 1995 Nissan 240sx?
Shove it John Paul! I have done about 10 5 speed swaps. The first one took me 2 days of on and off work. The second one took me 3 hours. It is the same job as doing a clutch and add drilling a hole in the firewall and switching a couple wires. Done! Find a shop that has done it before. I would pay a shop the same amount a clutch job cost plus and hour. No more then $500. You can get all the parts new/used for about $800. You can find a used trans for $100 sometimes. Here is the only link you need - http://www.240sx.org/links/installs/s14_5speed_swap.htm
How much would an automatic to manual transmission swap cost.?
You would be far better off selling this car and using the money from the sale to buy a car with a manual transmission. First off, since you even needed to ask this question in the first place tells me that you do not have the mechanical skills to do any of the wok yourself. You will need to pay a professional mechanic to do the work for you. Figure on about $100 per hour labor. Figure on at least 30 hours labor. So start with $3000 for the labor alone. You will need a transmission. Figure on about $1500 for the transmission. You will need a flywheel. Figure on about $500 for the flywheel. You will need a clutch, pressure plate, and throw out bearing. Figure on another $1000 You will need the clutch pedal assembly and a new brake pedal assembly, usually sold as a unit. You will also need the hydraulics for the clutch. Junkyard parts will be another $100. You will need a shifter, linkage, and a new center console. For junkyard parts figure on another $100. You will also most likely need new drive shafts. Add another $300. Add this all up and you see that you could easily spend $6500 for the privilege of shifting gears and using a clutch. You may recover some money by selling your old parts. However these would be worth no more than junkyard parts plus would be a pain in the behind to sell. Figure on getting about 10 cents on the dollar to get rid of them. You might get a couple hundred for them. This is why I recommend selling the car and getting one that already has a stick. Your 2004 Lancer OZ Rally is worth about $6500 give or take. A 2004 Lancer Evolution is worth between $13,000 and $15,000. Your current car with all the money that you just spent for a manual transmission would still be inferior to the Evolution model although you will have spent the same amount of money. Your current car would be worth no more money than it was before you started, maybe worth less. You would still be better off selling this car.
How much would an automatic to manual transmission swap cost?
It depends on what vehicle and what manual transmission. In general, on a rear wheel drive vehicle, swapping out the auto for a stock style manual isn’t terrible. Stock manual transmission assemblies can run anywhere from $1000 to $2000 on common vehicles. Removal and replace usually takes between 5 and 8 hours. Adding a clutch pedal and mounting a cylinder depends on the vehicle and again, whether it is aftermarket or stock bolt in. The problem is, you can’t always just bolt stock replacements back in. If the parts aren’t modular, then adding a pedal can take some time.Swapping out the flex plate for a flywheel and installing a clutch only adds about 15 minutes to the overall labor time.I doubt that manual and auto trans on any vehicle are exactly the same length, so the driveline probably needs to be cut and re-welded. This part of the job would be outsourced by most shops and may run 100–300 bucks. Measuring everything properly so accurate info can be given to the driveline shop takes time. Pinion angles must be checked with the new driveline and in some cases must be adjusted which sometimes requires different spacers being installed under the rear axle.Measuring and cutting a hole for the shifter and boot takes time. Re-wiring the neutral safety switch takes time as well.So, you have the parts cost of transmission, pedal assembly, reservoir, clutch fluid hose or cable, clutch kit, flywheel, driveline modification, any additional brackets that must be bought or made, shifter boot and neutral safety switch swap.Then you have the standard labor of removing and installing the trans, plus the extra labor of making everything work. The extra labor cost is very hard to pin down without knowing what vehicle and if you are going with nice, aftermarket parts or trying to stick with stock parts.Trying to covert a front wheel drive vehicle to manual has potential to be easier. It would be (possibly) easier and cheaper to just buy a complete motor/trans assembly and swap out the whole thing. Sensors might need to be modified and some holes cut in the firewall, but anything can be done.So, I dont know. On old trucks you might be able to do it for 2500 if you buy all new components. On newer vehicles it gets more and more expensive the newer you get as more and more components must be modified or swapped.
How much does it cost to change a automatic to a manual transmission?
It would cost many thousands of dollars. It would be cheaper to just sell the car you have and buy the one you want.
Why do automatic cost more than manual transmission cars? Are they really more expensive to produce?
Because an automatic is a lot more complex and due to the fact that there is no clutch or input shaft the gearbox has to be designed differently. There also has to be a computer to figure out what your current RPM is and what speed you are going and then figure out which gear you are going in.The car requires a torque converter as well because of the lack of a clutch. While a manual has gear ratios on an input shaft, automatics have a series of planetary gears and clutches in the gearbox as well as an oil system wth its own pump. All of this means that an automatic gearbox is much more complex to manufacture and therefore more expensive which the company that makes them then puts onto the customer.
How much does it cost to change a manual car into an automatic transmission?
You dont always have to put a tranny cooler on. If it is a small enough car it wont need it. Those are ussually for big trucks. But your still gonna be bent over with the price because you have to get the tranny, a torque converter, and replace the flywheel with a flex plate. Then you might need a new drive line too. If u drive a manual right they are more fuel efficient anyways.