TRENDING NEWS

POPULAR NEWS

Replacing Manual Tranny With Automatic In 2002 Hyundai Accent. Pump Isnt Working In Tranny. Does

I am buying a Hyundai Elantra 2002. Is that a good car?

I am buying this car and the owner is asking for $4000. The year is 2002 and the mileage is 66000. I will be the second owner of the car.
My questions are:
1. Is Hyundai a reliable car for a student? I have to drive for 20 hours to go to another state in Summer and need a car that wouldn't leave me in the middle of nowhere.
2. What are some of the problems with this type of car that you suggest I need to check? previous owners please.
3. Is the price the owner is asking fair?

Thanks.

Why does my car momentarily lose power after shifting gears?

You've asked several questions here...and also given some information that may have an impact on the answers you might get.   You mention that the clutch is about to "go".  If this is the case, it is typically manifested by "clutch slip" which is when you press the accelerator and the engine speeds up, but the car doesn't go any faster..i.e. the clutch is "slipping" against the flywheel/pressure plate without transferring the increased rpm of the engine to the transmission.  If the clutch is indeed slipping, then this phenomenon is most noticeable right after you change gears, because your putting more demands on the engine (i.e. accelerating) and attempting to put more torque from the engine into the transmission (via the clutch) which causes it to slip more than it might in steady-state driving at a constant speed.   If you are experiencing a slipping clutch you most likely need to replace it and afterward the car should accelerate smoothly and there will be a synchronicity between engine speed and car speed.Now, if your clutch is NOT slipping and your experiencing a perceived loss of power after shifting gears, it may just be that the engine rpm are dropping off too far before you reengage the clutch and resume acceleration.  If this is the case, you may be taking too much time between disengaging the clutch (by pressing the clutch pedal) and re-engaging it (by lifting off the clutch pedal)  When shifting gears, the clutch pedal should be pressed and released fairly quickly as part of a smooth, movement synchronized with moving the shift lever from one gear to the next. If you are pausing in the middle of the shift, or taking too long to reengage the clutch, the engine rpm will fall and the engine will be making less power than it was at the higher rpm level it was when you initiated your gear change.  The idea is to keep the engine in a range of rpm that produces enough power to smoothly take up the level of acceleration you're trying to achieve while changing up through the gears.

My 2002 dodge neon won't start. I've replaced the battery, starter, cleaned cables, changed the ground cable,?

it doesn't turn over, just clicks. You can get it to turn over but still not start. There is no pressure in the fuel pump . All the warning lights come on when the key is turned on. The heater fan even comes on. Any ideas on what is wrong? Could this be a fuse problem ? It has also been suggested that the cars "computer" is no good.

What are some symptoms of too much transmission fluid?

Excess transmission fluid will cause foaming in any transmission. Foam does not flow like oil, reducing cooling and lubrication. It also implodes on compression between gears or in the hydraulics of automatic transmissions, causing severe damage (pitting).In an automatic transmission, you will have higher temperatures and poor shifting, as it depends on solid hydraulic pressure, not spongy foam to move the clutches and bands.Automatic transmissions with dip sticks should be measured with the engine running, and consider the operating temperature. Note here how the heat affects the measurement. It should not be filled to the top when cold, or checked not running.If it does not have a dipstick, it is measured with the plugs on the side, depending on specific instructions per brand of car.Manual transmissions normally don't have dipsticks (some do). They are checked from a plug on the side of the transmission, and the level should normally be at the level of the plug, not above.

TRENDING NEWS