Esp bas light is on my Chrysler and wont turn off?
Your Electronic Stability Program (ESP) Indicator Light / Brake Assist System (BAS) Warning Light is a common issue with Chrysler's. The first thing to check is the electrical system. Remove the battery posts and clean them well. Next is to check the ground connection at the bulkhead, under the hood and the positive connections at the fuse box and boost pin. If all that checks out OK, check under the main fuse box for loose / corroded plugs and wires. These are the known, common problems. The fluctuation in power would cause the PCM to momentarily go into limp mode causing bucking on decell. Also have the OBD trouble codes read, including the ABS system. To reset the ESP/BAS light, with the engine running, in park turn the wheel right to left, lock to lock twice.
How do i reset the airbag light on a 2008 chrysler sebring myself?
On most vehicles, the airbag light should come on for @6 seconds, and then go off if the system is working properly. If there is a fault or a problem in the system, the light will remain illuminated, or flash continuously. If the airbag light does not work properly, some vehicles have an audible tone that sounds indicating a problem with the airbag light system. When the light is on (or the tone is sounding), the airbag will NOT deploy, even in an accident. This website gives you the procedure for diagnosing and resetting airbag lights on the ...scanlist.aspx page listed below. The flashing light on your car is telling there is a problem. On some vehicles, the light is flashing a two digit code. Your vehicle will require a scan tool for the proper diagnosis (and not the one at Auto Zone---it needs to be airbag system specific, like a good body shop or the dealer). Here's a site that will explain everything you need to know about airbag lights and resetting the system. Once you know the code, you can most likely repair it yourself. There are fairly easy procedures that most people are capable of repairing. Airbagsolutions.com has the fault code charts to tell you what is wrong! Although it’s a pay site ($14.95/day), it’s a lot cheaper than going to the dealer. Some vehicle manufacturers accommodate systems without a scanner (like Toyota, Lexus, Nissan, Infinity, Honda, Acura, Ford, Lincoln, Mazda & Mercury) . Most all other vehicles require a scan tool for the diagnosis. Here is a link to the list of vehicle and scanner requirements. Check out these websites also for more info on airbag systems and the light. Lastly, check your vehicle for recalls through this link.
06 chrysler 300 taillights keeps blowing the fuse?
Check the wiring in the trunk. Especially any on the floor for rust. Usually when this happens, it's caused by water on the floor mat and rust and corrosion on the wiring.
Where is the fuse on a 2007 chrysler 300 for the brake lights?
Your owner's manual should tell you where the fuse box is, AND which fuse you need to check. I agree with the other guy... ALWAYS use a fuse tester. It's sometimes nearly impossible to tell if a fuse is blown without one.
What does it mean when a car's battery light turns on while the car is moving (eventually car decelerates and stops)?
The alternator is failing or has ceased functioning. Whereas the engine's torque is usually giving your car constant electricity using the alternator, when it fails to do so the battery's reserved power is then used. Usually the battery is only used to start the vehicle. It obviously has enough power to spark the plugs, but only for so long, especially if you are also running your radio, A/C, headlights, etc. Once the battery is dead, the car is dead.This happened to me more than once. The alternator has a finite life in every car, so there comes a time when it will die, and it will almost certainly not be at the most opportune moment. Recognize signs of this happening before it is too late. Mine was failing for months before it inevitably gave in and I finally figured out what was wrong. A similar issue is if your serpentine belt snaps, the engine is no longer running your alternator, whether it's in good shape or not. This will cause more issues than the car just dying in five minutes- the water pump will cease functioning to cool your engine down and you will eventually overheat it and perhaps irreparably damage the vehicle.There are possibly other things that can cause this issue but this seems by and large the most likely.
Why do my hazard lights work, but not my turn signals?
Hazard lights and turn signals use the same bulb, so it is not the bulb, the lamp, or the cables to them. Turn signals only work when the ignition is on; hazard lights work whether the ignition is on or not. The two systems have separate power supplies, so they have separate fuses. You may have a blown fuse.Different vehicles use different circuits, and it is not possible to accurately diagnose the fault with the small amount of information provided. You need a circuit diagram and a voltmeter, and a continuity tester. First locate and test the turn signal fuse. Do you have voltage to and from the turn signal switch?The hazard light switch is not a simple on/off switch. In the “on” position, a fused battery feed connects to left and right turn signal. In the “off” position, the left turn switch wire is connected to the left turn lamp and the right turn switch wire is connected to the right turn lamp, so there are 3 inputs and 2 outputs.The fault could be a fuse, turn signal switch, hazard switch, flasher unit, or a broken wire or connection.
Where is the fuse located for the fog lights on a pt cruiser?
If your PT Cruiser is a 2005 or newer, there is no direct fuse for the fog lamps. They are powered through the TIPM. Fuses 8 and 17 provide power to the tipm for front lighting. Good luck.
My car starts but dash and interior lights wont come on. Why?
You should immediately take the vehicle into your nearest Chrysler dealership as they DO have the sophisticated tools and their mechanics are factory-trained to handle these problems. Or you can go to Joe's Shadetree: The Parts Changer who will not only charge you between $50 to %100 to "fix" it. Joe's fix will most likely work for a day or two, max. Then you will need another $600-$800 for the next 2 days, if he doesn't burn the car to the ground. The dealership will be your besty way to go IF you wish to have your car fixed RIGHT the first time at a resonable cost.
How do you locate a fuse box on a 2005 Dodge Caravan?
Try looking in the owner's manual. If you don't have a copy lurking in your glove compartment, you can download it for free from the Dodge website. If you download the PDF, you can easily search for "fuse" and find the places where the manual talks about fuses.In the 2005 Caravan, the fuse box is under the hood, near the battery. It's called an "Integrated Power Module," but it probably won't be too insulted if you just call it a "fuse box."The list of fuses continues on pages 413 and 414.
What does it mean when the traction control light comes on?
It may mean you have a problem.All cars and light trucks since the 2012 model year have come with standard traction control, and many vehicles from earlier years that had antilock brakes also got traction control. That’s because traction control piggybacks on the antilock brake system and uses the same wheel-speed sensors to control wheel slip during acceleration. Traction control and ABS are the basis of the stability control systems the federal government has required since the 2012 model year.As with antilock systems, the wheel-speed sensors, wires, connectors, control module and other components can occasionally conk out or suffer intermittent problems. The sensors, wires and connectors at each wheel live in a hostile environment of potholes, water, snow, dirt, tar, stones, other debris and more, so they take a beating and can fail.A problem in the system will usually illuminate a dashboard warning light that traction control is disabled and, in some cases, ABS as well. (When ABS is disabled, you should still have normal braking ability, just without the antilock feature.) This is different from momentary illumination of the light; that warning light should always come on for a couple of seconds whenever you start the vehicle and when the system is doing its job. (Common Problems with Traction Control)Read more at Common Problems with Traction Control